Sikorsky CH-37
1/72
Special Hobby kit
Click on the
thumbnail for a full size image
There
is a lot of very small photo etch in this model. The frames
behind the pilot seats are too wide to fit within the canopy as they
are installed here balanced about the seats.
I
would find a way to narrow them up if I build another of these.
The canopy was a bit too narrow for the fuselage so I installed it
before installing the cockpit so I could
spread
the canopy and superglue the corners to get a better fit. I also
had to sand down the upper fuselage behind the canopy to fair it
in. When I slipped the cockpit
assembly
in from underneath later on I found that it was too wide and the seat
frames and some of the resin had to be removed as well to get a good
fit.
CH-37 Index Page
My Models Index Page
John
Eaton Home Page